Description and Uses
Original Color Chips Waterborne Epoxy Primer is a two-component liquid epoxy emulsion. It's a low-solids epoxy
designed to sink deep into the concrete substrate to allow subsequent coatings better adhesion and uniform sheen.
It can be applied on interior floors, walls, ceilings, and machinery equipment. It hardens to a tough tile-like finish.
Particularly suitable on almost any surface, in areas where an inexpensive, easy to clean and wear resistant coating
is required. This waterborne epoxy primer can be used to prime a concrete substrate for use with waterborne, solvent-
borne, or 100% solids epoxy products.
Characteristics
· Water basedTechnical Information
· No smell, non-toxic, ideal for in-plant applicationColor:Gray
during normal operation.
· EconomicalSolid content: Per volume34-35%
· Resistant to mild corrosive chemicals Per weight40-45%
· Highly scrub and wear resistant Varies with color
· Allow for easy application
· WashableV.O.C. 110 g/l (0.92lbs/US gallons)
Mixing ratio: 3 parts A to 1 part B (hardener)
Application Instructions per volume
Surface Preparation
All surfaces to be coated should be free of wash, oil,Pot life: 2 hours
grease or any other contaminant. Should be properly
etched using chemical or mechanical means.Application Spray, roller, or brush
Method:
Application
It is recommended to stir part A before adding part BCoverage: 250 sq. ft. per kit
as some soft setting may occur in the containers
during storage.Recoat time: 8 - 12 hours
Mix parts A and B mechanically for 5 minutes inCuring time: Dry 8 hours
recommended proportions. Full cure 7 days
Apply thick using a 3/8" nap roller for best results. Thinning solvent: Water
Recoating: You can recoat over this product at the Cleaning solvent: Water
point where you cannot leave your fingerprint in the
epoxy. If you press your finger onto the coating and Shelf life: 2 years in original unopened
you cannot see your fingerprint you are ready to apply container
your next coat.
Packing: 1 US gallon / 3.78 liters
Precautions
· Do not apply material at temperatures below
0°C (32°F).
· Do not freeze.
· Material might be affected by certain corrosive
chemicals.
Waterborne Epoxy Primer Coat PDF
